Start of framing up trunk and rear fenders
With the trunk lid cut free and the back of the car mounted I need to get it all squared up good before I can build inner fenders and stuff. I tried a few different things to get everything to sit square and finally came up with a way to get it all lined up. I clamped a section of 1 inch square tubing to each side and shimmed it out to get everything sitting right. It was a simple way to hold it together and didnâ€™t need any duct tape.
Now that I have a nice even gap around the trunk lid I can start to build up a lip in the trunk to seal the lid when closed. I am not completely sure what I am going to use to make it. I need something strong enough to not let the fiberglass warp over time so I am thinking of forming up something out of metal and fiberglassing it onto the body similar to how I did the expanded metal on the hinge setup. I thought about trying to use foam to make a form and fiberglass that in the car. I will work on some ideas and see what works best. One good thing will be if I can keep the inner fenders separate from the fenders I can make the whole back body easy to unbolt and drop off the back of the car without all the hassle of the one piece trunk lid. I will work on that after I get everything framed up stiff and can keep it from warping.
Here is what the back end looks like with all the mess cleaned out of it. It has way more room than it did before. Once the inner fenders and trunk area are done it should work out perfect.